A Guide to Injection Rate in the Plastic Injection Molding Process
Injection rate is the amount of material that has been injected into a mold cavity for a specific period. This can be measured in pounds per hour, cubic centimeters per minute, or kilograms per hour. It is important to know how to control injection rates to maintain an even flow and prevent defects such as sink marks and gate marks from forming.
This
article will explain the process related to injection rate in the plastic injection molding
process.
The Process
The
molding material enters the injection unit through the hopper. The material is
then heated to its molten state, except for thermoplastic elastomers (TPE), which are typically not
heated because they do not require much force to fill a mold. The molten
material is pushed under high pressure into the barrel via the feeder
mechanism. This causes the material to
flow through the screw channel.
The
barrel is one of the primary components in the plastic injection molding
process. The barrel is composed of a metal tube with a screw attached to it. As
this screw rotates, it pushes forward and forces plastic against the walls of
the barrel until eventually, it pushes out through an opening in the back of
the barrel, known as the screw tip or nozzle.
The
opening of the barrel is called the sprue plate. The sprue plate allows molten plastic to be
delivered into a mold cavity before it hardens. It also prevents air from
entering an injection molding system and acts as a funnel for all plastics to
go through.
The
injection unit is a mechanism that pushes molten plastic through a metering
device, which meters the flow of molten material into a mold. The amount of
plastic flowing from the metering device determines the injection rate.
Injection units have been used in many different ways over past years until
finally being used today with single, multi-cavity, and multi-station injection
molds.
Calculation
To calculate injection rate, you must know
these three variables:
1. Cycle Time
2. Scrap Percentage
3. Shots-per Hour or Minute
Example of Injection Rate Calculation for a
Injection Machine
Using the Formula: CR = C/(D*L). CR = Cycle Time (minute), C = Number of
Cavities in mold, D = Fast / Slow shot ratio, L = Number of shots per hour
What is the injection flow rate?
The flow rate should not be confused with
the injection rate, which deals with how much material is injected into a mold
cavity in a certain period of time. Injection flow rate deals with the amount
of material that flows through all components of the injection molding system
for a specific time period.
PTMS is an ISO9001-2008 company since
2002, and They've been leading in the plastic injection molding industry for over a decade. They're
proud to offer exceptional service, timely delivery of your parts, and a variety
of manufacturing options that can fit any budget or need. PTMS offers services
from plastic injection
tooling design, mold
making to plastic
injection molding masss production.
Contact them for more information!
Comments
Post a Comment